CQR PADP2/SS/G1, Инструкция по установке

Страница: 3 / 4

3
Installation Instructions
Mounting
Undo the two cover screws to remove the front cover from the Backplate.
Fix Backplate to mounting surface using suitable fixings.
Wiring
Route the cable through the access holes in the rear of the Backplate.
Connect control panel PA zone/circuit to the two reed switch terminals inside the
PA Button (not polarity conscious) as shown below.
Refit cover to PA Backplate.
Backplate Diagram
Note: Three extra terminals are provided for terminating other circuit wires.
Connect wiring to Control
Panel PA circuit / zone
Mounting holes
Extra Terminals