CPS Bale Net, Инструкции, Страница: 2 / 4

BALING PROCESS
■
Feed crop evenly, from side to side.
■
Make sure net is tight on roll.
■
Make sure the net is cut clearly, to avoid loose threads.
■
The net should always be on the outside of the bale.
When the netwrap starts feeding, use the brakes and stop moving, otherwise
the bale continues being formed and part of the net will end up inside the crop.
■
Check that the tailgate, belts and chamber rollers are not damaged.
■
Comply with the machine maintenance instructions and check all relevant parts.
2
■
Drive in a straight line – do not zigzag.
Bale shape should be uniform and flat across its surface.
■
The bale should be ejected from the baler immediately when the tailgate is opened,
to avoid any damage on the bale surface that spinning rollers in the chamber
may cause. If the bale gets stuck in the baler, reduce speed or disengage PTO
to reduce the friction of the rollers against the bale surface.
■
Also check that the baler is correctly aligned in relation to the tractor
so that the bale can be ejected swiftly from the tailgate.
■
For over edge, use nets specially designed
for this purpose (130 cm, 51 or 67 inches wide),
otherwise the lines will spread too wide and the bales may burst.
MINIMUM RECOMMENDED LAYERS:
3
BALE
DIAMETER (M)
BALE CHAMBER
WIDTH (M)
SILAGE HAY
STRAW
CORN STALKS
/ RAPE STRAW
1,2 1,20 2,5 2,5 3,5 3,5
1,50 3 3 3,5 4
1,60 3 3 4 4,5
1,80 3 4 5 5
2,00 3 4 5 5
BALE CHAMBER
WIDTH (M)
SILAGE HAY
STRAW
CORN STALKS
/ RAPE STRAW
1,2 1,20 2,5 2,5 3 3
1,50 2,5 3 3 3,5
1,60 2,5 3 3,5 4
1,80 3 3 4 4,5
2,00 3 3 4 5
BALE
DIAMETER (M)