6
www.CookingPerformanceGroup.com
1-800-678-5517
USER MANUAL
•
All Cooking Performance Group appliances are adjusted and tested before leaving the factory, effectively
matching them to sea level conditions. Adjustments and calibrations to assure proper operation may be
necessary on installation to meet local conditions or adapt to low gas characteristics; correct possible
problems caused by rough handling or vibration during shipment and are to be performed only by qualified
service personnel. These adjustments are the responsibility of the customer and / or dealer and are not
covered by our warranty.
•
Check all gas connections for leaks with a soapy water solution before lighting any pilots.
•
Turn the control valve to position 0, or OFF.
•
Make sure all knobs are in a closed state.
•
Wait for 5 minutes.
•
Turn pilot valve(s) by adjusting the screw counter clockwise, then light standing pilot
and adjust flame ¼ inch high.
• If not lit immediately, wait 1 minute for existing gas in pipe to disperse, and try again after 1 minute.
•
Turn ON gas valve(s) to light the main burner.
•
For complete shutdown, shut OFF gas valve(s) and turn pilot valve(s) by adjusting the screw clockwise
to shut off gas to the pilot(s).
•
Wait 5 minutes before next use.
•
Turn off range, remove all objects, and disconnect energy source.
•
Remove control panel, cooking grates, pilot light head, and burner
•
Remove main energy nozzle and replacement with other gas source by screwing it in clockwise.
•
Reinstall burner, pilot light head, cooking grates, and control panel in proper order.
•
Have authorized technician adjust input appropriately.
•
Remove control panel and unscrew damper solid screw
•
Rotate damper to desired opening, observe flame, and adjust to appropriate degree
•
Tighten screw damper solid screw to ensure equipment will not get loose in transportation
•
Reinstall control panel.
INITIAL PILOT LIGHTING
LIGHTING & SHUTDOWN
ENERGY CONVERSION
ADJUST AIR INPUT
CAUTION: When lighting pilots and checking for leaks,
do not stand with your face close to the combustion chamber.
!
!
