9
100189
ENGLISH
ASSEMBly
Grease can be applied to the plastic spacers if needed
for grip upon reinsertion of hardware and tube .
NOTE
Assemble the primary (1-2 bike) frame, by taking the
support base assembly (A) and connecting the horizontal
tube (H) using two cap screws (N), lock nuts (P), flat
washers (L), and four plastic spacers (O) . Make sure
the bolt on the end of the horizontal tube is facing up .
Be sure to re-insert the two (2) plastic spacers inside
of support base before inserting square horizontal tube .
Align two small pins into the holes provided .
Attach the primary (1-2 bike) support base assembly to
hitch mounting assembly (D) . Be sure to insert plastic
spacers (R) into square tube before attaching to hitch
mounting assembly using screw M12x80 (Q) and lock nut
M12 (S) . Use metal strap and pin Ø8 x 85 mm and pin
Ø12 .6 x 8 mm for extra safety .
Assembling the bike carrier cont’d.
Assembling the Bike Carrier
Remove hardware already in the support base prior to
any assembly or inserting tube .
NOTE
1 . The primary support base frame will NOT have a
reflector at the end of the tube .
NOTE
2 . Insert plastic spacers (2) onto each side of square
tube prior to assembly to hitch mounting assembly
assembly .
NOTE
1
H
2
Make sure the centre bar is in the upright and locked
position . Slide the notched key slide into the centre hole
and turn to ensure it’s locked . Using your hand or a
phillips head screw driver (not included), unscrew the bolt
on the ends of the horizontal tubes .
1
2
3
4
Slide the wheel cradles (B+C) onto the horizontal tubes
(A+H) . Adjustment knob should be facing up . Loop end
of cradle should be facing outward and upward . Insert
cradles in sequence as shown below . After all 4 cradles
are on the horizontal tubes, replace the end bolts and
tighten using a phillips head screwdriver (not included) .