CPA AMBRA, Руководство пользователя, Страница: 8 / 8

MANTEINANCE MANUAL
AMBRA
pag. 8 di 8
www.cpa-piscine.it
Ver01 – 2021-06-18
Problem Cause Solution
Air intake from the seal
mechanical
Replace the mechanical seal
Excessive intervention of the
thermal protection
Not correct voltage
Check the voltage present on the line
(qualified technical personnel)
The impeller is hindered in rotation
Check the integrity of the
impeller. Clean the impeller
Defective capacitor Replace the capacitor
Lack of water leakage in the
first minute after starting
Air infiltration in the suction pipe Check and if necessary repair the pipe,
checking its hermetic seal
The pump starts without
water
Water leakage from the pipeline o
from the pump
Repair the piping, pump or connecting
points between parts
Loss of water from the estate
mechanics
Replace the mechanical seal
Insufficient flow of water
Reached the level limit
suction
Check the water level in the suction basin
Filter, pre-filter and / or valves
clogged or blocked
Verify clean / repair the components
associated with the piping and the pump
Impeller blocked Disassemble the pump and carefully
clean the pump body and impeller
(qualified personnel only)
Failure to prime
Presence of air Check the mechanical joint
Transparent perforated plastic cover Clean the clear plastic cover and check
the gasket
Wrong motor direction Electrical check
High absorption Adjust the absorption
Wrong voltage Check the voltage of the power line
No water in the filter basket or in the
pump body
Fill the filter basket or pump
housing with water
Absence of water for priming Fill the suction tube with water
Little reach
Presence of air Check that the lid is closed
correctly
Wrong motor direction Check the electrical wiring
High absorption Adjust the absorption
Wrong voltage Voltage check
Blockage in the filter basket Clean the filter basket
Dirt in the pump housing Clean the pump body
The engine does not start
and makes noise
Impeller block Impeller washing
Water leaks in
function
Damage to the mechanical seal or
dirt absorbed by it
Clean the mechanical seal or change it
NOTE
− CPA srl excludes any liability for non-compliance with the safety standards in force for the individual technical sectors affected by this
document.
− The information contained in this manual may vary at the discretion of the editor, without notice, together with the changes to the product in
question in this document: it will be the responsibility of the customer to verify the persistent correspondence of the product to the information
sheet when placing the order.