CP Plus Ezykam EPK-HC10L1, Инструкция по эксплуатации, Страница: 45 / 49

45
Solution
: Check the internet connection and settings.
Possible Reason 2
: Port forward is not set in router.
Solution
: Set the port forward of extranet in router correctly.
For example, if IP Camera address is: 192.168.1.100, Media port is 38401, Web port is 85, factory DDNS is
http://test.aipcam.com.
Set Port forwarding in the router .
This is an important step. You need to set port forwarding in your router, to refer to the IP of your camera correctly, for
DDNS to work. There are so many kinds of routers, so it’s difficult to show fixed steps, but here are some samples of
different router’s port forwarding settings, just for reference
:
TP-LINK:
1. Login to the router .
2. Choose “
Forwarding
”, select “
Virtual Servers
”
3. Click the Add New button, pop-up below:
Figure 13.1
Fill in the service port (
don’t use 80
), IP address of the camera, then click Save
NOTE
: The port and IP address should be the same as the camera.
Fill in the
web port,
for example port 85, IP address as 192.168.1.100, click Save.
(1) Repeat step 3 above, it will pop-up the window again, fill in the
media port
as 25001, IP address as
192.168.1.100, then save.
(2)
Then check the “Device Info” –“DDNS Status”,
It will show DDNS: http://test.aipcam.com:85 , input this link in IE, then you can visit this camera remotely.