STEP 3:
Cut the cable tie, used for shipping, securing the backrest actuator.
Remove the protective material which wrapped on the head of backrest actuator.
Remove the cotter pin and bolt and set aside. As pictured below.
Remove the protective material.
Remove the cotter pin and bolt
and set aside.
STEP 5:
Take backrest out of box2 and remove the plastic bag.
Use the Allen Key attached to the cardboard and remove the two bolts on the
side of backrest, then remove the cardboard.
STEP 6:
Preferably using two people, carefully set the backrest on the cradle points on the
base. With the backrest in a vertical position, ensure it properly engages to the base.
Caution: DO NOT rest the backrest onto floor while it is vertically otherwise will
damaging the backrest bracket maybe occur.
Remove the cardboard.
Set the backrest on the cradle points on the base.
the backrest properly engages to the base
Push the backrest forward and let it lean on
the seat pad.
Aline the two brackets.
STEP 7:
Push the backrest forward and let it lean on the seat pad.
Use the bolt and cotter pin to attach the backrest and backrest actuator.
Remove the two screw.
The backrest take out with a cardboard on it.
