CozyCab A-11289, Инструкция по монтажу, Страница: 3 / 26

05-10433
May 2004
Mounting Instructions
John Deere 2210
PREPARATION OF TRACTOR;
1. Park tractor and disconnect battery power.
2. Remove steering wheel.
3. Remove rear amber flashing lights from roll bar.
4. Attach amber lights to single or dual light
mounting brackets #7-15827 and #7-15828.
Secure lights to bracket with; (See Figure 4).
(4) 8mm x 25mm cap-screws #3-10123
(4) 5/16” lock washers #3-10077
5. Secure brackets to each side of cab using;
(4) ¼-20unc cap screws x ¾”lg #3-10219
(4) ¼-20unc ser flange hex nut #3-14924
(4) ¼” flat washers #3-10084
6. Install (2) Dual Light Wire Extension Kits #8-
14726 and route wires into roll bar where factory
rear light wires were routed. See Figure 6.
Secure wires with (8) nylon ties, 3-16494.
INSTALLING FRONT MOUNT BRACKETS
7. JD factory loader brackets
are not
required to
mount the cab’s front mount brackets #7-15803
and #7-15804.
8. If the tractor model
does not
have a loader,
install (2) Spacers #6-43373 using (4) Metric
bolts 3-17372 and (4) ½” lock washers 3-10079,
with the cab’s front mount brackets.
9. If tractor model
does
have a loader, remove (4) of
the JD front loader bolts and install (4) 12mm x
40mm bolts with the front mount brackets.
Spacers are not required if tractor has factory
JD loader mounts
. Install (2) rubber isolators #3-
16635. NOTE: Rubber Isolators (#3-16635) with
pipe bushing should be inserted from the top-side
of mount. See Figure 8.
Figure 4
Figure 6
Note 4
Note 5
Figure 8
(Model shown has JD Loader Brackets)
Front
Mount
Bracket
Note 8 & 9
Note 6
Note 6
Rubber
Isolator
3-16635
(Note 9)
No
Spacer
(Note 9)
JD Loader
Bracket
Page 3 of 26