CF353C, CF354C, CF503C, CF504C, CF653C, CF654C - -
STANDING PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot, which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone
in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
1.
STOP! Read the information on the safety label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
Remove cabinet door.
5.
Push in gas control lever slightly and slide right to
“OFF”.
6.
Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the information on the safety
label. If you don’t smell gas, go to the next step.
7.
Locate red piezo ignitor button. Locate pilot. (Follow
metal pilot tube from gas control).
8.
Slide gas control lever left to “SET” and hold.
Immediately begin a series of pushing and releasing
the red piezo ignitor button, while observing the pilot.
Continue to spark until pilot is lit. Continue to hold
the gas control lever to “SET” for about one (1)
minute after the pilot is lit. Release the gas control
lever and it will return to “PILOT”. Pilot should
remain lit. If pilot goes out, repeat steps 5 thru 8.
•
If gas control lever does not return to “PILOT” when
released, STOP and immediately call your service
technician or gas supplier.
•
If the pilot will not stay lit after several tries, slide the
gas control lever to “OFF” and call your service
technician or gas supplier.
9.
Slide gas control lever left to “ON”.
10. Replace cabinet.
11. Turn on all electric to the appliance.
12. Set thermostat to desired setting.
1.
Turn thermostat to lowest setting.
2.
Turn off all electric power to the appliance if service is
to be performed.
3.
Remove cabinet door.
4.
Push in gas control lever slightly and slide right
to “OFF”. Do not force.
5.
Replace cabinet door.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
Gas Control
Lever
MAX. (HIGH)
PRESSURE REGULATOR
NOTE: Lever
cannot be
moved to
“OFF” unless
it is pushed
in slightly.
Do not force.
STEP PRESSURE REGULATOR
OUTLET (MANIFOLD)
PRESSURE T
AP
PILOT BURNER
The pilot is located
on the side of the
burner
Page 10
Содержание CF353C-R and
Страница 28: ......
