Check socket with Connector and insert
1.
Place Small Integrator™ in desired location on mold and
trace location. Install o-ring
2.
Drill 3/8” hole for nylon knot. Prep cast in customary fashion
3.
Ensure nylon will fit fully under Small Integrator™ to keep
socket airtight.
4.
Glue Small Integrator™ to mold in desired location
5. Install insert of choice (CD103MDI or CD103SDI) into
Alignable Connector (CD103AF)
6.
Slide connector onto Small Integrator™ in desired location
with posts facing away from Small Integrator™
7. Place foam dots on posts
8.
Fabricate over mold, Small Integrator™, and connector
We typically drape copoly, but other plastics and
methods can be used.
When plastic has cooled, expose foam dots, and grind the bottom
of the socket as flat as possible without damaging posts
Using the Alignable Connector a single lamination with built in
offset alignment can be done. For more information see
instructions with Alignable connector
CD103MDI
CD103SDI
CD103AF