Coyote C1P28, Инструкция по использованию и уходу

Страница: 28 / 37

27
8. Failure to clean or polish your grill in accordance with the instructions above
Ways to Avoid Rust on your Grill:
1. Purchase a Coyote Grill cover for your unit. This will ensure that your cover is a correct fit and breathable,
while providing the protection needed to keep contaminants off of the surface.
2. When installing the unit, make sure to keep the unit covered when any masonry work is being performed. If
any mortar or dust does come into contact with the stainless, make sure to wipe it off as soon as possible
and use a stainless steel polish immediately afterward.
3. Position your grill away from areas that can receive water splash from a pool or hot tub.
4. Do not store pool chemicals in your island or island cabinets.
How to Remove Scratches from your Stainless Steel:
If your situation is a little more serious and you have obtained scratches in your equipment, then you will need
to purchase a third-party stainless steel scratch kit. These kits are popular in retail stores but can be easier to
obtain online. With these kits, you will not polish the unit until you are done re-scratching the entire product
you are working on. With a scratch kit, the goal is to literally re-scratch the entire surface, so that the original
grains are replaced by your new scratched-in grains. With this practice, you must be willing to treat the entire
surface or you will notice a start and stop point. Also, be careful to pay attention to your rolled or finished edges
as these scratch kits will ruin this finish. After you have used the kit, you will want to follow it up with a good
stainless polish (as mentioned prior) and then a dry towel for a final wipe down. Follow all directions on any
third-party stainless steel scratch kits. Coyote does not insure or guarantee the performance of or results from
such products.
HOW TO CHANGE THE LIGHT BULBS
1. Remove the screw holding the bulb lens.
2. Reach in using your fingers only, grip the two outside edges of the light bulb. Do not grip the top or bottom
of the bulb, as it might break. Pull the bulb straight out, so that the two electrode wires are completely
removed with bulb. Place bulb in trash.
3. When installing the new halogen bulb be sure to use a clean cloth or paper towel to ensure the longevity of
the bulb.
4. Insert the new bulb using your clean cloth and gently snap it into position. Wipe off any fingerprints and/or
grease that may have transferred to the bulb.
5. Re-install the bulb lens and cover
6. Flip the switch on to check lights.
CLEANING OF GRILL HOUSING
1. After each cooking session, or before you start one, you should give the entire grill a thorough cleaning to
keep it in top operating condition.
2. Allow grill to cool down completely.
3. Remove and clean the cooking grids, heat shield and burner pot.
4. Remove warming rack and wash with mild detergent and warm water.
5. Brush the inside and bottom of the grill with a stiff wire brush, and wash down with a mild soap and warm
water solution. Wash thoroughly and let dry.
6. Reinstall heat shield, cooking grids, burner pot and racks as needed.
7. Reconnect to power source.