Coyote Point Systems Equalizer GX Series, Руководство администратора

Страница: 304 / 866

System Settings
Configuring Subnet Destination Routes
Subnet destination routes (also commonly called "static routes") are commonly used to specify
routes to destination IP addresses via gateways other than the subnet’s default route (also called
a
default gateway ). They are called destination routes, since they are used to make routing
decisions based on a packet’s destination IP address.
default route can be specified for every subnet (previous releases supported a single global
default route). If you need to access systems on another subnet that cannot be reached via this
gateway, then you need to specify a static route to those systems through the gateway for that
subnet.
subnet also has its own subnet-specific static route table. Subnet static routes can be specified via
the CLI or the GUI.
Also refer to
"Source Based Routing Scenarios"
on page 119 for a description of source-based routing
scenarios.
Configuring Subnet Static Routes using the GUI
Do one of the following:
1. In the GUI, click on the
System
configuration tab if it is not already selected. Then click on
the arrow (
u
) beside
VLANs
to expand the branch. Click on the arrow (
u
)beside a VLAN to
expand the branch to display the subnets. Right-click on the name of a subnet and select
Add
Static Route
.
or
2. In the GUI, click on the
System
configuration tab if it is not already selected. Then click on
the arrow (
u
) beside
VLANs
to expand the branch. Click on the arrow (
u
)beside a VLAN to
expand the branch to display the subnets and select a subnet.
The following will be displayed.
304 Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.