Cowfish Technologies VanConnect, Руководство пользователя и инструкция по установке, Страница: 7 / 38

Page 6
Verify that your SIM card has been activated by your carrier. If you are using
the included Telstra pre-paid SIM card, following the following steps:
1. Have your driver’s license handy.
2. Use the Service Number located on the rear bottom space of the Telstra
Satchel.
3. Open your browser and go to www.telstra.com/activate
4. Follow the Telstra prompts for activation.
For providers other than Telstra please look on their packaging for
instructions to activate.
To install your SIM card, insert it into the SIM slot with the gold contacts
facing down. The VanConnect accepts a standard SIM card size. If your SIM
card is a micro or nano SIM, please use the included adapter. There is no need
to use the adapter if your SIM card is a standard SIM. When installing the SIM
card, push the SIM card gently until it locks into place.
Caution: Always unplug/power down the router before installing or removing
the SIM card. Never insert or remove the SIM card while the router is in use.
Attach the included internal antennas to the connectors on the the sides
of the router, screwing them in clockwise. Ensure that 3G/4G antennas are
connected to the “3G/4G” points and that the WiFi antennas are connected
to the “WiFi-2.4 INT”, “WiFi-2.4 EXT”, “WiFi-5.8 INT” and “WiFi-5.8 EXT”
points. The 3G/4G antennas have a male connector that connects to the
female “3G/4G” recepticles on the VanConnect. The “WiFi-5.8“ WiFi antennas
have male connectors that connect to the female “WiFi-5.8” recepticles on
the VanConnect. The “WiFi-2.4“ WiFi antennas have female connectors that
connect to the male “WiFi-2.4” recepticles on the VanConnect.
Note: An incorrect installation of an antenna can result in damage to the
antenna and the VanConnect unit.
After connecting the antennas, arrange them so that they point upward or
downward. A vertical position is required for optimal signal.
Page 7