Safety
Information
Operating
Instructions
T
roubleshooting
T
ips
C
ustomer
S
ervice
09
10
HOW TO USE
Preparation Before Use
How to Drink Water
Make sure that there’s no water leakage before plugging in the power
cord.
WARNING
Step1
Step2
Step3
Step4
Put the extraction pipe in the
desired position and place the
cup under the extraction faucet to
collect the water.
Turn the faucet on and off
depending on desired use of
filtered water.
●
This unit is the R/O type of purifier which needs an appropriate
inflow quantity for proper performance. If the unit is set up in a
way where the installation status is substandard, a malfunction
such as excess noise and trembling can occur.
●
The warning light for water shortage turns on for safety when
the feed water pressure suddenly drops, or the inflow quantity
decreases.
●
This device is installed in one of two ways, depending on the
usage conditions.
●
This product operates auto filter-flushing for 3 minutes after
installation. Please make sure that the line is connected.
▶
The Usage Condition : The feed water is more than 2.5L/min, 17psi.
If the system does not work when
the faucet is opened, push the
restart button for one seconds to
restart extraction.
Water extraction automatically
stops after four minutes to prevent
too much use of water or
overflowing around the product
caused by user’s carelessness.
After repeating for eight cycles, this
device will auto flush and then shut
off.
�
Step1
Step2
Step3
Step4
Wind the teflon tape on the
adaptor and fit it to the pipe.
Connect orange tubing with the
connector on the adaptor.
Connect the extraction fitting to the
faucet with a tube.
Make a hole on the drain pipe
and install the drain clamp on
the hole.
Step5
Step6
Connect it to voltage rating
that matches it on the rating
plate.
Then, open the feed valve to
supply water to the filtration
system.
Connect the orange colored
inlet tubing for the feed water
with the cold water pipe.
Extend the blue color outlet
tubing to where the drain is.
Shall install the adaptor with
connector on the cold water pipe.
Flush water through each filter at
least 5 minutes before connection.
Then, connect the faucet with the adaptor.
Inlet tubing
Outlet tubing
�
�
●
●