System Setup
Valleylab FT10 Energy Platform User’s Guide
3-9
Service and Settings
5. Touch
EXIT DEMO
to close DEMO mode and return to the functional monopolar
screen. This will enable REM.
System Menu
The System button accesses settings for
•
System Config
•
Diagnostics
•
Network
•
Time Zone
•
Calibration Info
System Configuration
System Configuration displays the hardware, software, and firmware components of the
VLFT10GEN. This information is for reference only. No changes to the configuration can
be performed from this screen.
Diagnostics
•
Instrument Bar Code Reader
—Insert a Covidien device with a scannable bar code.
When the SCAN button is touched, the bar-code reader displays the current view from
the reader’s camera to verify it is working properly.
•
Self Test
—Runs the same system test as the power-on self-test when the system is
turned on. Current power and mode settings in each quadrant will be lost as the
system is reset to run the power-on self-test. These settings can be retrieved by
pressing the Restore Settings button on the front panel. If the self-test is successful, a
tone sounds.
Warning
Use of a non-REM return electrode while in DEMO mode does not monitor the quality of pad
contact with the patient. Therefore, no warning will be issued from the generator when pad-to-
patient contact degrades.
