Covidien Newport e360, Руководство по обслуживанию

Страница: 91 / 154

Exhalation Flow Sensor Board (GR-PCB2103P)
Service Manual 4-31
To remove and reinstall the exhalation manifold, refer to Figure 4-24. and Figure 4-25. , and perform
the following steps:
1.
Turn the ventilator so the bottom of the unit is facing upward.
2.
Remove the three screws securing the exhalation manifold to the base of the ventilator.
3.
Remove the screw and washer securing the bumper (BMP2100P) to the bottom of the ventilator.
4.
Remove the exhalation valve drive line and the machine 2 pressure line from the rear of the exhalation
manifold (see
Figure 4-23. ).
5.
Remove the exhalation manifold from the ventilator.
6.
Reinstall the exhalation manifold by reversing steps 2 through 5.
4.23
Exhalation Flow Sensor Board (GR-PCB2103P)
Figure 4-26. Exhalation Flow Sensor Board (GR-PCB2103P)
To replace the exhalation flow sensor board, refer to Figure 4-26. and perform the following steps:
1.
Remove the exhalation manifold by performing the procedure in section 4.22 , “ Exhalation Manifold .”
2.
Remove cable GR-CBL2127A from K1.
3.
Remove GR-CBL2124P from K5 on GR-PCB2103P.
4.
Remove the two screws and washers securing GR-PCB2103P to the exhalation manifold.
5.
Remove GR-PCB2103P.
6.
Reinstall the exhalation flow sensor board by reversing steps 1 through 5.

Note:
There is a small hole adjacent to K1 on GR-PCB2103P. The hole polarizes the connector.
1 GR-CBL2124P connected to K5 on GR-PCB2103P 3 Polarization hole for K1 on GR-PCB2103P
2 CBL2122A connected to K1 on GR-PCB2103P