Covidien Nellcor GR101704, Руководство по обслуживанию

Страница: 133 / 236

Performance Tests
Service Manual 10-11
6.
Disconnect the monitoring system from AC power.
7.
Verify the AC Power indicator is not lit.
To charge the battery
1.
Connect the monitoring system to an AC power source.
2.
Verify the AC Power indicator is lit.
3.
If the Low Battery indicator is also lit, leave the monitoring system connected to
an AC power source to charge the battery.
4.
Check the battery charge.
10.6
Performance Tests
The monitoring system automatically sets the Alarm Mode for adult alarm set-
tings at power on. Do not change this selection to neonate alarm settings for
any of these tests.

Note:
This section uses factory defaults. If the institution or caregiver using the monitoring
system customized the defaults, the monitoring system displays those customized
values. Reference
To restore factory defaults , p. 10-7.
10.6.1
Power-On Defaults and Alarm Ranges
Power-up performance tests verify both power-on self-test (POST) and power-
on defaults and alarm range limits. Reference
Power-on Self-Test (POST) , p. 6-4.

Note:
Power-on defaults are factory settings or defaults set by the institution.

Note:
The descriptions below are based on the default pleth view with SatSeconds and the
Saturation Pattern Detection (SPD) feature enabled. The steps for changing an alarm
limit are the same for all views.