600568 Rel-0006
Coverlink™ Wireless Control
Troubleshoot Guide
Qualified service personnel only
PROBLEM
SOLUTION
Auto-shutoff Verification
Cover system does not operate or
operates intermittently.
Step 1. Check for secure wiring connections at the Circuit Breaker
,
Auto Shutoff Board, Receiver Board, and Motor.
Check that the Antenna wire is secure and not damaged.
All wiring is good, go to step 2.
Step 2. Reboot the receiver:
Turn the system power off to the receiver and auto-shutoff
board, leave it off for 30 seconds, then turn the system power
back on.
Step 3. Use the CoverLink override buttons on the receiver
(Uncover & Cover).
If the buttons work, go to Troubleshoot CoverLink.
If the buttons do not work, go to step 3
Step 4. Disconnect the receiver from the auto-shutoff. Short the key
switch wires together (
Black to Yellow should cover the pool &
Black to Green should uncover the pool
).
If the Auto-shutoff works, go to Troubleshoot CoverLink.
If the Auto-shutoff does not work, see Document 600356 Adjusting
the AMP Limiter and LED Function of the Auto-shutoff.
6 of 7
Verify that the Auto-shutoff board is working properly prior to troubleshooting the CoverLink system.
©Cover-Pools Inc.
E
le
c
tr
ic
a
l D
e
ta
ils
7
:2
4
6 of 7
600568 Rel-0006