600568 Rel-0006
1 of 7
The CoverLink Wireless Control system controls access to pool cover operation. The CoverLink Wireless Control
uses a Personal Identification Number (PIN) in place of a Key. Entering a valid PIN into the Control Pad allows
access to the cover and uncover operation for the pool cover.
COVERLINK WIRELESS CONTROL FEATURES
CoverLink Control Pad and CoverLink Receiver
The CoverLink Control system is
factory programmed and ready for use.
THE CONTROL PAD MUST BE MOUNTED IN FULL VIEW OF THE POOL COVER.
Control Pad
features:
•
Up to 3 separate Control Pads can operate the same pool cover.
•
Up to 4 unique 4 digit PINs can control access to the pool cover.
•
Control Pads can be setup in different locations around the pool.
•
A Master PIN that is stored in memory location 1 (Factory Default Master PIN: 1583).
•
Additional PINs can be stored in memory locations 2, 3 and 4.
(
The pool owner should keep a record of PIN to
memory
location, for reference
).
•
A unique signal that is sent from the Control Pad and stored by the Receiver when linked.
•
Each Control Pad must be linked to the Receiver and set to:
»
The same channel number and the same network ID number
Receiver
features:
•
3 control buttons:
•
32 usable Channels:
•
100 Network ID numbers:
»
Uncover
»
00 - 31
»
00 - 99
»
Cover
»
Setup
•
Typically the Receiver and Auto Shutoff board are located in an enclosure by the pool cover
electric motor.
CoverLink Control Pad
Green
LED
Red
LED
Antenna Wire
Connection
CoverLink Receiver
Green LED
Red LED
Setup
UnCover
Cover
Red
Black
Green
Y
ellow
YELLOW
RED
BLACK
BLUE
WHITE
ORANGE
WHITE
Auto Shutoff to CoverLink Receiver
Green
LED's
YELLOW
GREEN
BLUE
ORANGE
BLACK
PURPLE
BROWN
RED
BLACK
AUTO SHUTOFF
AMP LIMIT
AMP
LIMITER
(LOW VOLTAGE WIRES)
(HIGH VOLTAGE WIRES)
Setup
Uncover
Cover
Instructions
Coverlink™ Wireless Control
Operation and Programming
©Cover-Pools Inc.
1-800-447-2838
1 of 7
600568 Rel-0006
E
le
c
tr
ic
a
l D
e
ta
ils
7
:1
9
