ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
STOP DON’T RETURN TO STORE!
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic
holders attached on the underside of the table top
(#1) rim. Fasten them together by using screws
(#4). See Figure 1.
PAGE 1 OF 2
FIGURE 1
TGS37SC
1
2
3
4
4
1
4
1
5
6
7
8
1
8
8
8
TGS37SC-CS05-1
TGS37SC-CS04-1
62TGS37SCY101
17C17A0403001Y4
17KAA0201----Y4
18000337002
17FA05040301-Y4
17C01A0706002Y4
BOLT M6*16
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX.KEY WRENCH 6MM
PARTS LIST
PART
NO.
MATERIAL CODE
Q’TY
PART
PART
NO.
MATERIAL CODE
Q’TY
PART
TABLE TOP
LEG
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #8)
2
2
2
2
1
4
Attention:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
COURTYARD CREATIONS INC.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
!
!
!
!
!
!
!
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote following FQC NO. when contacting service center.
