PAGE 5 OF 7
Step 11:
Insert the seat arms (#8 and #9) into the seat
supports (#10 and #11) and fasten them together
by using plastic joint covers (#30), bolts (#18),
washers (#22), and plastic nuts (#27).
See Fig. D – Step 1.
Note:
1. The label marked "back" on the right seat arm
(#8) should coincide with the label marked
"back" on the seat rear support (#11) to ensure
proper assembly.
2. The clip holder side of the seat rear support
(#11) must face the inside of the swing and
the opening side of the clip holder must be
facing upward.
Step 12:
Open the seat assembly (#12) and attach its
back to the seat arms (#8 and #9) by using bolts
(#19), washers (#23), plastic washers (#31), and
jam nuts (#25). Repeat the same procedure for
both sides. See Fig. D – Step 2.
Step 13:
Make sure that the support brace on the seat
assembly (#12) is fully inserted into the clip
holders on the seat rear support (#11).
See Fig. D – Step 3.
Step 14:
Attach the swing arm tubes (#13) to the seat
arms (#8 and #9) by using bolts (#20), washers
(#22), and plastic nuts (#27). Repeat the same
procedure for both sides. See Fig. D – Step 4.
Step 15:
Hook the suspension springs (#24) into the top
of both holes of the swing arm tubes (#13). Do
the same procedure for both sides.
See Fig. D – Step 5.
back
back
back
back
Fig. D
STOP DON’T RETURN TO STORE!
back
back
8
8
10
19 23
23 25
31
34
12
12
11
13
13
13
13
13
13
13
27
27
22
22
22
22
20
20
33
33
13
24
24
24
24
11
30
18
22
22
27
33
9
9
8
9
support brace
Step 1
Step 2
Step 3
Step 4
Step 5
back
back
