PAGE 3 OF 6
Fig. A
Note:
When fastening with bolts and nuts, always use
a washer (#19 and #20) between the tube and
the bolt and the tube and the nut.
Step A - 1
Step A - 2
Step A - 4
Step A - 5
Do not tighten the bolts
after Step 1. Fasten all
bolts after Fig A.
Step A - 1 :
Fasten the front and rear upright supports (#5
and #6) at the top by using bolts (#14), washers
(#19), and plastic nuts (#21). Do the same
procedure for both sides. Keep the bolts loose.
Step A - 2 :
At both ends, insert the assembled upright
supports (#5 and #6) into the top cross beam
w/adjustable teeth (#1). Tighten all of the plastic
nuts and bolts.
Step A - 3 :
Fasten the lateral cross braces (#3 and #4) to the
upright supports (#5 and #6) by using bolts (#15)
and washers (#20). Do the same procedure for
both sides.
Step A - 4 :
Fasten the rear cross brace (#2) to the rear
upright supports (#6) by using bolts (#16),
washers (#20), and plastic nuts (#22). Tighten all
of the plastic nuts and bolts.
14
14
19
19
19
21
21
19
Step A - 3
STOP
DON’T RETURN TO STORE!
1
5
6
5
5
5
5
6
6
6
2
6
6
3
4
6
15
15
20
20
16
22
12
12
12
12
20
20
Note :
1. Do not fasten the lower rear holes of them yet.
2. To ensure proper assembly, the label marked
“L” and “R” on the lateral cross brace (#3 and
#4) should coincide with the label marked “L”
and “R” on the front upright supports (#5).
R
L
L
R
V-3
Step A - 5 :
Insert the leg caps (#12) into all of the base feet.
