ASSEMBLY INSTRUCTIONS
KTS889W
-WM
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PART
NO.
MATERIAL CODE
PART
Q’TY
1
2
3
4
5
1
1
1
1
1
6
2
7
8
9
10
11
12
13
14
15
16
17
18
19
2
6
12
2
2
6
2
4
1
1
1
2
2
PARTS LIST
STOP
DON’T RETURN TO STORE!
PAGE 1 OF 3
COURTYARD CREATIONS INC.
RIGHT ARM
LEFT ARM
BACK
ASSEMBLY
SEAT
ASSEMBLY
OTTOMAN
BOLT M6*16
BOLT M6*14
BOLT M6*50
BOLT M6*39
WASHER d6.5*D13*1.0
PLASTIC NUT M6*P1.0
PULLEY A
PULLEY B
BOLT CAP
BOLT CAP M6
BOLT CAP M6
HEX.KEY WRENCH 4MM
HEX.KEY WRENCH 6MM
NUT WRENCH 10&13MM
KTS889W-CS01-3
KTS889W-CS01-2
KTS889W-CS03-1
KTS889W-CS02-1
17C02A0755131Y4
17C01A0717072Y4
17C21A0713081Y4
KTS889W-CS04-H
17C33A0706001Y4
17FA05040301-Y4
18000C23001
18000613017
18000613018
18000337004
18000337006
18000337002
17KAA0101----Y4
17KAA0201----Y4
17KAB1101----Y4
Use the correct bolts as indicated. Do not tighten any of the bolts until the lounge chair is completely assembled.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
Attention:
Make sure that each bolt needed for all steps matches the
corresponding figure to ensure proper assembly.
Step 1:
Place the right arm (#1) onto a non-abrasive surface, such as
a carpet, with its pre-drilled holes accessible. At the rear of the
chair, fasten the seat assembly (#4) to the right arm (#1) by
using bolts (#6) and washers (#10). Keep the bolts loose.
See Figure 1.
Note:
The labels marked “L” and “R” on arms (#1 and #2) should
coincide with Figure 1 - Figure 3 to ensure proper assembly.
FIGURE 1
16
6
6
1
4
14
14
10
10
#6 BOLT M6*16
R
