STOP
DON’T RETURN TO STORE!
PAGE 2 OF 5
95
#9 BOLT M8*95
Step 1
Step 2
Step 3
45
#11 BOLT M6*45
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
You will need the following tools
- Phillips Screwdriver (Not Included)
- Nut Wrench (See Part #18)
- Hex.Key Wrench (See Part #19)
Attention:
Make sure that each bolt needed for
all steps match the corresponding
figure to ensure proper assembly.
Step 1:
Fasten the middle leg (#6) in the
center of the middle seats (#3) by
using bolts (#9), washers (#14), and
jam nuts (#16). Do not fully tighten
the bolts yet. See Figure 1.
NOTE:
The labelled arrow marks on the
middle seats (#3) should be facing
upwards to ensure proper assembly.
Step 2:
Insert the seat bases (#2) into the
middle seats (#3). Please ensure that
their holes align. Do the same
procedure for both sides.
See Figure 2.
NOTE:
The labelled arrow marks on the seat
bases (#2) should match those on the
middle seats (#3) to ensure proper
assembly.
Step 3:
Insert the seat bases (#2) into the seat
bases (#1). Make sure the spring clips
on the seat bases (#2) come through
the holes on the seat bases (#1).
See Figure 3.
NOTE:
The labelled arrow marks on the seat
bases (#1 and #2) should be facing
upwards to ensure proper assembly.
Step 4:
Insert the connector tabs on the seat
bases (#1) into the legs (#7). Make
sure the spring clips on the seat bases
(#1) come through the boles on the
legs (#7). See Figure 4 - Step 1.
Fasten the middle seats (#3) to the
seat bases (#2) by using screws (#12).
See Figure 4 - Step 2.
Fasten the middle leg (#6) to the legs
(#7) by using bolts (#11) and washers
(#13). See Figure 4 - Step 3.
