10
14.
TO FREE WHEEL MACHINE: UNLOCK
TRANSMISSION: Unscrew both bypass
valves between ½ to 1 full turn
counterclockwise. To reset, turn valves
clockwise.
DO NOT OVERTIGHTEN.
NOTE: The tractor should never be pulled at
more than 2 miles per hour or for any
appreciable distance.
15.
TO INSTALL DISCHARGE CHUTE
(52” TRI-PORT DECK, ONLY): Rotate
the Latch handle upward, insert the
chute into the provided holes in the side
plate. Slide the chute toward the rear.
Rotate the Latch handle to lock the
Discharge Chute in place.
To remove Discharge Chute, Lift up
Latch handle, slide Discharge Chute
forward and remove.
CAUTION
NEVER OPERATE MOWER WITH OUT
DISCHARGE CHUTE
MOWING RECOMMENDATIONS
1.
Keep mower blades sharp.
2.
Make sure deck and discharge are
clean.
CAUTION
POWER MUST BE OFF TO CLEAN
DISCHARGE CHUTE. TURN ENGINE OFF
AND WAIT FOR ALL MOVING PARTS TO
STOP.
3.
When mowing tall grass, make two
passes, mowing off 1/2 of the desired
cut on the first pass, and then the
desired height the second pass. Check
for hidden dangers first.
4.
Go slowly for trimming.
5.
Always cut grass with the engine at full
throttle speed. This “ENGINE” speed
allows the cutting blades to operate at
optimum cutting speed. Control
“GROUND” speed with the Control
Lever(s).
6.
Vary ground speed to suit conditions
(i.e. go slower in tall thick grass, on hills,
wet conditions, etc.).
Hydrostatic Transmission
Bypass Valve
(one on each hydrostatic
transmission)
Discharge
Chute
Latch in Locked
position
