Count KF-250, Руководство пользователя

Страница: 26 / 27

26
CHECKING THE SENSORS
1. Turn machine power on and allow screen to turn on
2. There should be 2 lights on the sensor; a green indicating power is getting to the sensor and
orange that is the reflecting signal. If both lights are not on, there is a problem and must be
fixed before you are able to run.
3. Make sure the sensor reflector tape is located on the base plate and the red beam from the
sensor is hitting the tape. If not, loosen the screws on the sensor and adjust the beam until it is
on the tape.
4. If all above steps work correctly, the sensor is working properly, if not, contact the service
department.
ROTATING PLASTIC COVER
This cover is not only a safety cover it also provides paper support for folding longer sheets in
half. There is a safety switch that the cover engages and must be pressed or the machine will
not function. Be very careful when opening this cover. Open it slowly and close it slowly as to
make sure it does not break.