10
BI-PASS TRAY INSTALLATION
As shown below, there are hooks that hold the bi-pass tray into position. If the magnetic paper
stops have already been placed, you should remove them for easier installation of the tray.
First, angle upward and insert the upper hooks into the upper slots and then rotate downward
to place the lower hooks into the lower slots.
PAPER STOP ASSEMBLIES
There are two different paper stops. One will have a bend and one will be straight. The straight
paper stop is the rear or back paper stop. The bent paper stop is the operator side paper stop.
There is no paper stop for the non-operator side. The support arm acts as the stop for that side.
They hold their position using a magnet which makes it easy for adjustment. The positions for
the paper stops will change for each individual job. If the paper stops are set too close the
paper will hit them as it exits the machine and will cause a paper jam. If they are set too loose,
the paper will stack in an unorganized manner. Getting the position correct is imperative to
smooth operation of the machine.
Содержание KF-250
Страница 2: ...2 Page left blank intentionally...