ADJUSTING THE RAC ROLLERS
The RAC rollers are set from the factory and it is
NOT
recommended to make any
adjustments to this without consulting with Count’s tech-support department.
Should an adjustment be necessary, please follow the steps below.
Loosen the small bearing block lock screws. This allows very slight adjustments of the
bearing block to be made by loosening the thumb lock and turning the height
adjustment screw in the middle of the bearing block. This is a very fine thread and is
capable of making very slight adjustments. Turning the adjustment screw clockwise will
increase the bar pressure, as counterclockwise will decrease the pressure. Once the
adjustment to the bar has been made, slightly tighten the thumb lock and re set the
block set-screws.
ADJUSTING RAC TOP DEAD CENTER
The top dead center of the RAC will need to be adjusted from time to time. To do this
turn the machine off, remove the operator side cover, and manually rotate the eccentric
shaft to the top dead center. Then locate the adjusting shaft collar on the end of the
eccentric on the operators side and take a 5/32 allen wrench and loosen the button
head screw and rotate it to the 6 o’clock position. This will ensure proper alignment of
the crease bar.
18
To ensure proper adjustment make
sure the eccentric drive shaft is at top
dead center.
Use the button head adjustment
screw to the 6 o’clock position.