4
EN
GL
IS
H
• Disconnect the tool from the compressed air for transporting.
• Check frequently that both the trigger and the safety catch are working properly.
• Do not take apart any part of the tool.
• Make no provisional repairs.
• Always have authorized personnel do servicing and repairs, and only with original
replacement parts.
• Avoid weakening the housing by engraving or scratching it, etc.
• Always make a note of where the electric cable goes into walls, floosr or ceilings
before you begin to use the nail gun.
• The compressed air fitting for the nail gun must be of the quick-coupling type.
The connecting piece on the tool may not have a rear valve so that some air
remains under pressure when the nail gun has been disconnected.
Compressed air feed and connections
Warning!
To prevent accidents due to unintended firing, the operator
should always disconnect the compressed air:
• Before adjusting
• When cleaning the nail gun
• When removing a stuck nail
• When the tool is not being used
• When moving the tool to another work area
Warning!
• Use only compressed air in pneumatically driven tools. Never use acid or
flammable gases to drive the tool since they carry the risk of explosion.
• The compressor capacity must be sufficient to ensure an adequate air pressure
and flow for the intended use. A fall in pressure in the system can reduce the
tool’s thrust. See
Specifications
for setting the right pressure for the tool.
• The compressed air lines should be mounted on an incline, with the highest
point closest to the compressor. An easily accessed water separator should be
installed at the lowest points. The water separator should be emptied at least
once a day, or more often if needed. Dirt and water in the compressed air lines
are the many causes of wear in pneumatically actuate tools.
• The tool connection fittings should be equipped with a reducing valve with water
separator directly at the connection site. A filter helps to achieve maximum effect
at minimum wear. The filter must have sufficient flow capacity for the intended
mounting site or connecting point. The filter must be kept clean if it is to be able
to deliver clean compressed air to the tool. See the manufacturer‘s instructions
for proper filter care. A dirty or clogged filter will cause a fall in pressure, which
reduces the nail gun’s effectiveness.
