EN
G
LI
SH
31. Do not try to stop the blade by pressing something against the side of the blade when you have turned
off the power-supply to the saw.
32. Never use saw blades which do not comply with the specifications in this manual.
33. It is important to always check that all covers on the saw blade are functioning well.
34. Never lock the protective hood in the open position and never disassemble the machine’s cover and do
not alter their function. Never use a damaged or faulty safety appliance. Replace it immediately!
35. Make sure you keep hands in a safe position, so that they do not end up in the saw blade if you lose
balance. Never saw pieces that are too small to be held in a safe manner.
36. To avoid tipping the machine, use a table; roll support etc if the work material is long.
37. Clamp tightly round work pieces with proper appliances, to prevent rotation.
38. There must never be nails or other foreign objects in the piece you are going to saw.
39. Always stand to the side of the saw blade when the machine is in use, to avoid being struck by the
blade if it should break.
40. Always press the workpiece against the table and the guide fence when sawing to prevent it from
turning or moving during sawing.
41. Never saw several objects at the same time.
42. Never attempt to remove shavings, splinters or wood that has gotten stuck when the saw blade is
rotating. If you adjust the machine or remove pieces that have gotten stuck, always switch off the
machine first and pull out the plug from the mains.
43. If you change, adjust or clean the machine or measure the object, always switch off the machine first
and pull out the plug from the mains.
44. Switch off the motor and pull out the plug from the mains when you leave your work area.
45. Electrical installation, repairs or maintenance to the machine should always be carried out by
professionals.
46. All covers and safety appliances should be remounted immediately after repairs or maintenance.
47. It is important to follow the manufacturer’s safety, use and maintenance instructions, as well
as following the dimension specifications provided in the “technical data”.
48. It is important to follow the Health and Safety at Work regulations as well as other general
safety regulations.
49. The saw should always be connected to sockets with 230V fitted with at least a 10 A fuse.
50. Damaged safety appliances and parts should be replaced or repaired by professionals at an authorized
service centre.
51. This machine corresponds to all relevant safety regulations. The machine may only be repaired by
professionals at authorized service centres with original parts. If you do not follow this rule it could lead
to accidents and expose the user to danger.
52. Do not use the saw blades that are thicker or thinner than the riving knife (applies to circular saws).
53. Always use a riving knife when cutting.
54. Check that the riving knife is adjusted so that the distance between the saw blade’s teeth and the riving
knife is 3 mm or less.
3. Safety Symbols
Please read the entire instruction manual before using and save it for future use.
Warning!
Always use goggles or visors, a respirator and hearing protection.
Содержание CSB315
Страница 2: ......
