10
EN
GL
IS
H
a
b
c
3
1
4. Begin spraying outside the target area and move your arm in a smooth motion
from side to side or up and down.
5. Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
6. Let each pass of the spray jet overlap by 4–5 cm.
7. Do not interrupt the spraying action once inside the target area.
8. An even movement of the spray gun results in an even surface quality.
9. Varying the distance or spraying angle will lead to the formation of paint mist,
resulting in an uneven coating.
10. Finish the spraying motion outside the target area.
11. Do not operate the spray gun until the container is completely empty. If the spray
gun can no longer feed paint to the nozzle during operation, there will be
an interruption in the spraying resulting in an uneven finish.
12. If either the paint nozzle or air cap are soiled, they should be cleaned with
the appropriate thinning agent.
Settings
Note:
Do not pull the trigger whilst adjusting the setting.
Spray pattern
Three different spray jet settings can be chosen:
a) Vertical, flat jet - for horizontal surfaces.
b) Circular jet - for corners, edges and hard-to-reach surfaces.
c) Horizontal, flat jet - for vertical surfaces.
1. Undo the lock nut (3) and set the preferred spray pattern by twisting the air cap (1)
to the relevant position. Refer to the symbols on the spray gun and turn the air cap
until it lines up with the relevant symbol.
2. Retighten the lock nut.
Содержание 40-9132
Страница 2: ...2 ...
