www.costway.com
DISPOSAL
WARNING: Repair patches must be
applied by an adult only.
KEEP OUT OF REACH OF CHILDREN.
INSTRUCTIONS FOR
INFLATABLE PROJECTION
MAINTENANCE
INSTRUCTIONS FOR
BLOWER MAINTENANCE
• As an outdoor product, the Inflatable Projection is subject
to wear and deterioration. Inspect for signs of fabric failure;
weak or torn surfaces must be repaired promptly.
• To keep the product clean: wipe the Inflatable Projection or
blower using a dry cloth or a cloth dampened with a neutral,
non-inflammable, nontoxic cleaning and sanitizing solution
or pure water.
• Product should never be stored wet. Allow to dry before
rolling up.
• Disassemble and dispose of the equipment in such a
manner that no hazardous conditions exist at the time the
equipment is discarded.
• Blower should be returned to a collection center
• Blower must be unplugged before servicing.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Product should be periodically examined for potentially
unsafe conditions such as damaged cord, plug, housing,
or parts, and that in the event such damage is found, the
product should not be used until properly repaired. If these
checks are not carried out, the product could overturn or
otherwise become a hazard.
• The blower does not require any lubrication and has no
user serviceable parts. Do not attempt to service the blower.
• Do not immerse the fan in water. To clean, wipe with a
damp cloth.
• Regularly check the intake and output openings and keep
free of dirt, leaves, etc.
• When not in use, store the blower indoors in a dry place.
• Store the blower upright on a stable surface.
• Loosely coil the cord and place it beside the blower.
• When in use, do not place the cord across traffic areas,
water or damp areas.
• The blower is a high volume blower, and is capable of
moving large volumes of air very quickly. Place the blower
in an area where it will not draw in dirt or leaves.
REPAIR PATCH INSTRUCTIONS
INSTRUCTION:
1. Deflate the item, clean the area and
allow to dry thoroughly.
2. Cut a portion of the patch to the size
needed and round the corners. (See Fig).
3. Remove the adhesive backing from the
patch material, position the patch over the
damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-inflating.
Please keep this manual as it contains important information.
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with other household
waste. Please use designated collection points or recycling facilities when disposing of the item.
06
Содержание OP70571
Страница 8: ......
