2
www.costway.com
3
www.costway.com
Contact Us!
Do NOT return this item.
Contact our friendly customer service department for help first.
US: [email protected]
UK: [email protected]
Before You Start
Before You Start
Please read all instructions carefully.
Retain instructions for future reference.
Seperate and count all parts and hardware.
Read through each step carefully and follow the proper order.
We recommend that, where possible, all items are assembled near to the
area in which they will be placed in use, to avoid moving the product
unnecessarily once assembled.
Always place the product on a flat, steady and stable surface.
Keep all small parts and packaging materials for this product away from
babies and children as they potentially pose a serious choking hazard.
No.
Part
Qty
1 Curved
Ring
Section
6
2
“W” Shaped Legs with Plastic Caps 2
3
Spreader Bar with Plastic Caps 2
4
Nut & Bolt and washer sets 11
Caution:
Before starting assembly read the instructions carefully as
incorrect assembly can cause misalignment.Study Fig 2.
Note on unpacking:
The Curved Ring Sections (1) are wrapped in 2 packs of 3
sections-Keep each pack separately as a set.
The difference being one section has an extra hole in the
centre. This is the base section (Fig 1 ).
Assembly:
Note:During assembly - DO NOT tighten Nut & Bolt Sets
1.Assemble one ring by placing each section of 3 on a flat
surface. Each section
should have a male fitting one end and a female the other.
These should easily slot together for 2 joins leaving a gap for
the 3rd join.
To fit the 3rd join together stand the ring up with the open end
to the top. Press down on the 2 open end so they meet and
slot together (Fig 1 ).The ring should then hold together without
any further fixing.Repeat for the second ring.
2.Place the 2 rings together making sure that the 4 holes align.
For aesthetics make sure that the joints on each ring are
together:
To determine which is the base of the rings, select the hole that
is in the centre of the section (Fig 1) (not at the ends)
Fit the centre of a Spreader Bar (3) to the outside of the base
section of each ring.
Fit the 2 rings together at the top using a Nut and Bolt Set.
IMPORTANT:Do not tighten the bolt set.Fit the nut level with
the end of the bolt.
3.Fit the “W” Shaped Legs (2) by gently spreading the base of
the rings and fit-ting to the outside of the rings.
4.Fit the Spreader Bars to the outside of the “W” Shaped
Legs (2).
5.Now Tighten the 10 Nut & Bolt Sets at the base of the unit
(DO NOT tighten Nut & Bolt Set at the top)
，
Put enough pressure
downwards so that
the 2 end join
↓↓
(Fig1)
Note base
section with
hole in centre
(Fig2)
Curved
Ring Section(1)
Spreader Bar(3)
“W” Shaped Legs (2)
