Wx2
Xx2
Hex Wrench
Open-end Wrench
PREPARATION
Before beginning assembly of product, make sure all parts are
present.
Compare parts with parts list and hardware list above. If any part is
missing or damaged, do not attempt to assemble. Contact customer
service for replacement parts.
ASSEMBLY INSTRUCTIONS
STEP 1 :
Place all chair parts on a protected flat surface. Assemble
Sway Bar (D) to Left Leg Tube (J) with M6 x 45mm Bolt (O), 5mm
Plastic Washer (T), Steel Washer (S) and M6 Nut (R). Do not tighten
the bolt fully at this moment.
Repeat for right Leg Tube (K). Once it is done, repeat for another
Sway Bar (D) at back. Next, assemble Back Cross Bar (C) to Right
Leg Tube (K) using M6 X 15mm Bolt (M) and Steel Washer (S).
Do
not tighten the bolt fully at this moment.
Repeat for Left Leg
Tube (J).
See Figure 1.
Figure 1
D
J
K
S
S
R
R
T
O
C
S
M
K
C
T
O
Mx4
Sx8
Rx4
Tx4
Ox4
04
05
