5
www.costway.com
www.costway.com
• Avoid heat sources: Refrigerator should be placed in a well-ventilated place, away from
heat sources, and avoid direct sunlight as far as possible.
• Place stably: The floor or car surface on which the refrigerator will be placed must be flat and
firm.When the refrigerator is placed in the car, pull belts should be pulled into box body fixed
position to fix the refrigerator firmly.
• The installation of 12V/24V dc power supply on board must be operated by a professional
electrician.
• When charging batteries, it is necessary to ensure that refrigerator have been disconnected
from power supply.
• Ensure that the product is connected to the correct voltage at all times. The parameters at
the bottom of the product are labeled with approved voltage parameters.
• Do not use electrical products inside the refrigerator.
• Avoid moisture: The refrigerator should avoid excessive moisture to reduce the chance of
metal parts rusting. Rinsing it with water will cause poor insulation, lead to leakage or out of
order.
4
3.Function And Operation
+
<
>
<
-
°
C
M
AX
—
Increase
Decrease
Set
Power
ON
/
OFF
-
20
• ON/OFF: Long press the button for 3 seconds, the refrigerator gets into startup/standby
mode.
Note: Shut down and start up again, the compressor has a 3-minute delay protection.
• Temperature control: Press or to adjust the setting temperature, that it changes and
memorizes accordingly. Stop operation, the panel will flash for 5 seconds and display the
temperature inside the refrigerator.
<
>
• Short press button, it flashes
℃
. Loop click button, it flashes ,
℃ ℉
V-,V V circularly
in turn, and enters the temperature unit and compressor speed setting state. After the
corresponding parameter flashing stops, the refrigerator saves the parameter settings.
-
-
--
-
Parameter Function
：
℃:
Celsius degree
;
:
Fahrenheit degree
;
ECO:Energy saving mode(compressor speed 3000R/min)
;
MAX:
℉
<
-
<
--
<
--
-
Fast cooling mode(compressor speed 2000R/min)
:
Battery voltage protection-Low
:
Battery voltage protection-Mid
Battery voltage protection-High
Note:The voltage level is testing the voltage value of input terminal of the
compressor
not the output terminal of the car battery
:
11.7±0.3V
10.7±0.3V
10.2
±
0
.
3V
12.7±0.3V
11.7±0.3V
11.2±0.3V
24.6±0.3V
22.6±0.3V
21.6±0.3V
26.0±0
.
3V
24.0±0
.
3V
23.0±0.3V
<
-
<
--
<
--
-
Battery voltage
protection
12V cut out
12V cut in
24V cut out
24V cut in
1.
;2.
；
3.
；
USB
DC power input(DC12/24V)
V
(
)
ent Do not block
charging port
4.
；
；
.
; .
5
6
7
.
Sealing strip Cabinet
Display panel
DC power line
7
6
5
4
3
2
1
Function:
Operation
The voltage protection will have ±0.3V tolerance according to different power
supply.
Display panel
