BATTERY INFORMATIO
N /
電池資訊
/ INFORMACIÓN SOBRE LAS
PILAS
INSTALLATION / REPLACEMENT INSTRUCTIONS
1
2
3
4
5
BATTERY WARNINGS
Do not use alkaline, standard (carbon-zinc) or NiCd (nickel cadmium) batteries in GTX solar lights.
Only use AA 1.2V 1000mAh NiMh rechargeable batteries (product includes 8 NiMh rechargeable batteries).
Do not mix battery types. Only use NiMh batteries.
Battery performance is affected by weather and temperature.
Please expect REDUCED performance in adverse conditions of cold, extreme cold, extreme heat plus humidity
and dampness.
Do not open, short circuit or mutilate batteries as injury may occur. Batteries must be recycled or disposed of properly.
Always purchase the correct size and grade of battery most suitable for the intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts prior to battery installation.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment that will not be used for an extended period of time.
Remove used batteries promptly.
SUGGESTIONS
Rechargeable batteries need to be charged for approximately 12 hours before using to perform correctly.
Our batteries come pre-charged but some discharge may happen during storage or transit.
Less than full sunlight during the day charges the batteries less. On cloudy days or rainy days it may take several
days for the batteries to fully charge.
+
-
2
ASSEMBLY / / ENSAMBLAJE
1
2
3
4
WINTERTIME TIPS
It is recommended that solar lights are not used in freezing conditions. Monitor weather and take solar items indoor for
storage as needed. Keep snow or other buildup off the solar panels so that the batteries are able to recharge.
TROUBLESHOOTING
If solar lights fail to come on
1.
Check to be sure there are no obstructions over the photocell located on the top of solar panel.
2.
Check to make sure that the batteries are installed correctly and there is nothing blocking the battery terminals
from making contact.
3.
Check to make sure the photocell is positioned to sense both daylight and night phase. If bright lights shine
near or into the photocell, these lights may trigger the light sensor and the lights may turn off. Bright lights can
PULL
組裝
