3. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top (See Fig. B). Remove protection cap, and insert the center
pole into the stand. Then slot together the remaining poles securely until the tree top is installed. Be sure
that all cords are free from branch hinges.
5. Plug the adapter into a wall outlet (See Fig. B), your entire tree should now be lit.
6. Just slightly upsweep all tips (See Fig. C) and shift branches to fill in any gaps for a fuller, uniform look. Your
Christmas tree is now ready to be decorated.
Top view
Side view
Fig. C
Page: 2 of 5
1. Remove all ornaments and decorations. For pre-lit trees, first unplug adapter from the wall outlet and then
disconnect light adapter between each section of the tree.
2. Disassemble the tree from the top to the bottom. Start with the tree top and gently lift straight up to remove
from section below and fold all branches toward the pole.
3. In case of difficulty separating the tree pole (trunk), apply a small amount of lubricant at the joint and rotate the
upper pole in both directions. Lift up the upper pole again.
4. Continue by gently lifting straight up each section(s) from the section below and fold all branches toward the
pole until the bottom section is removed from the tree stand.
5. Carefully place all tree sections into shipping box and tape it shut.
6. When not in use, please store your tree in a cool, dry place away from sunlight. Exposing your tree to excessive
heat or humidity may damage your tree.
7. Keep out of reach of pets and children.
STORAGE INSTRUCTIONS
Simply press the selector button to select from the following light functions:
1.CLEAR STEADY 2.CLEAR FADING 3.MULTI-COLOR STEADY
4.MULTI-COLOR FADING 5.CLEAR/MULTI-COLOR ALTERNATING
DUAL COLOR LIGHT CONTROLLER & REMOTE CONTROL
Remote
Control
Light
Controller
Selector Button
If extra parts are needed, please contact our customer service center.
SPARE PARTS
If Tree Does Not Illuminate / Some Bulbs Do Not Light or Flicker
Check to make sure that all connectors are properly connected and the adapter is plugged firmly into the wall outlet.
TROUBLESHOOTING TIPS
Insulation Tab
REMOTE CONTROL INSTRUCTIONS
1. Remove the insultation tab of the remote control.
2. Press either selector button and wait for a second to enjoy light effects in the following sequence
(see DUAL COLOR LIGHT CONTROLLER & REMOTE CONTROL).
