Costar Video Systems D&N series, Руководство пользователя

Страница: 19 / 32

30
1) Metal Bracket Fixed
) Power Connect & Monitor Impedance
- using 4 screws, affix the metal bracket to wall or other surfaces.
2
Made sure which power supply that you
selected before you use.
- DC12V regulated power supply (DC12V only)
Dual power supply (AC24V/DC12V)
- To avoid fire or shock hazard, must use a
UL listed power supply.
- Set the monitor impedance switch to 75½.
Check the impedance switch when the screen turns blurred.
3
) Focus Adjust
and Functions
- Loose the magnet-screw , and open the osd-cover , and use the extra cable to adjust
the focu
s and others functions . After finished, please tighten the osd-cover and
magnet-screw carefully .
Note
1. When you tighten the osd-cover, please make sure that you tighten well
and already adjust the function that you wish.
2. Before you connect the power , please check anywhere like that screw
and cable.
Camera Series
31
- As the connecting method varies with the instruments, refer to the manual
supplied with the instrument.
- If necessary, you can connect the monitor to the REMOTE jack on the back of
your camera.
- Only connect the cable when the power is turned off.
- Set the 75
Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
VIDEO
1) Connection to Monitor
2) Connection to Power
Connect the adaptor to the power input connector
as shown in the figure right. The Standard voltage
for camera operation : DC 12V ± 10%, AC 24V±10%.
Power Input
Note
If you wish to use RS-485 connection, verify the proper polarity.
2.8-12mm TDN Camera
Camera
Camera
Installation Connection
5-50mm TDN Camera
VIDEO
IR Bullet Camera IR Bullet Camera