8
USING YOUR GLASS KETTLE
Heating Water
Boil-Dry Protection
Keep Warm Mode
Only
heat water in this kettle. Use pure,
filtered water for best results.
1.
Press the
Lid Release Button
to open
the lid.
2.
Fill the kettle to the desired level. Make
sure the kettle is filled above the “
MIN
”
line and below the “
MAX
” line. Wipe
any excess water from the kettle’s body
and power base.
3.
Close the lid, place the kettle onto the
power base, and plug in. [
Figure 2.1
]
4.
Press a preset temperature button. You
can only select 1 preset at a time.
5.
Press
START/CANCEL
. The kettle will
begin heating. Press
START/CANCEL
at any time to stop heating early.
6.
The kettle will automatically switch to
Keep Warm Mode once it has finished
heating the water.
• This kettle has a boil-dry safety feature.
If there is no water inside the kettle,
it will automatically turn off to avoid
damaging the heating element. Fill the
kettle with cold water and allow it to cool
before using again.
• Keep Warm Mode automatically
maintains the selected temperature for
60 minutes.
• If you select the Boil Black preset, the
kettle will hold the temperature at 200°F
as a safety feature to keep the water from
boiling for too long.
• If you take the kettle off the base during
Keep Warm Mode, all lights will turn off,
and the kettle will pause heating. If you
put the kettle back within 60 seconds, it
will resume Keep Warm Mode. After 60
seconds, the kettle will turn off.
• Keep Warm Mode can be turned on/off
while the kettle is in standby mode by
pressing and holding
START/CANCEL
for 3 seconds. When Keep Warm Mode
is turned off, the
START/CANCEL
indicator light will change from blue
to white. If Keep Warm Mode is off, the
kettle will automatically turn off once it
has reached the preset temperature.
Figure 2.1
