11
4 - REHABILITATION PROCEDURE (BINDING)
Cosmobits and gateways are shipped already paired. In some cases this combination is lost, so it is necessary
renew it through the “binding” operation.
This operation must be performed even if only one of the two components is replaced.
To carry out the pairing, proceed as follows:
a - Hold down the button below the gateway until the green
light of the wifi icon flashes;
Green light of WiFi present on the gateway
b - Press the button below the display on the right side for
about 10 seconds until the word “bnd” appears;
c – the word “bnd” will appear on the display;
d - Briefly press the button below the display on the right
side again (see step “b” above). The Cosmobit will send a
request to connect to the gateway, confirmed by the icon
blinking at the top right;
e - if the connection failed: an alarm message appears for
4 seconds before the connection screen is displayed again.
Try again by pressing the right button. If no action is taken
within 30 seconds, the thermostat returns to the “room
temperature” display;
f - If the connection is successful: The display shows the
transmitted signal strength (digit 1 to 5);
g - After 4 sec the thermostat will display the room temperature
with the gateway connection symbol;
If the connection has failed the alarm message will continue to
flash in the upper right corner. Repeat the procedure bringing
the Cosmobit closer to the gateway;
COSMOBIT