INSTALLATION PROCEDURES
10
11
CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
INSTALLATIO N PROCEDURES
Cabinet Installation Method
1.
2.
Use the 4 screws to mount the Range Hood to the
cabinet. Check that your mounting screws are in
the correct place by temporarily fitting the Range
in place. If correct, lock into position by pushing in
For
Ducted
installation drill a 130mm diameter hole
into the cabinet and four 3.5mm diameter holes as
pictured below picture.
For
Ductless
installation
do not
drill the
5"
diameter hole in the cabinet. Drill only the four
3.5mm diamater holes as pictured below.
36" Model
A= 27.5"
B= 7.125"
30" Model
A= 25.0"
B= 7.0"
CAUTION:
HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE
ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.
1.
Drill two 8mm holes in position for
plastic wall a
nchor (Part B) placement.
(See
above
for placement location).
2. Tap
plastic wall
anchors securely into each of the drilled holes.
3. After Wall anchors have been tapped in place, Insert
ST4*40
wood screws
(part D)
, but
leave
1/4” of the screw sticking out of the wall. (This will give your Range Hood
something to hang onto).
B
3
0
” Model:
A=
25.6
”
B = 1 - 1/8"
A
CABINET
If
using recirculating mode
:
skip
step
s
4, 5a,
5c, 6
a, 6c
.
If cabinet bottom is recessed, we recommend installing wooden shims
on cabinet bottom
to make
cabinet mounting area flush.
