ON
AUTO
OFF
MANUAL
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
TEST / PAIRING
+
−
+
−
F R O S T P R O T E C T I O N
PA I R I N G T H E T H E R M O S TAT
W I T H T H E R E C E I V E R
S L E E P M O D E
I N S TA L L E R M O D E
R E S E T
1
1
1
2
1
1
2
2
2
1
3
2
2
Press
button to turn on/off frost protection.
When Sleep Mode is active all the thermostat functions will be
paused.
Press and hold TEST / PAIRING button for 3 seconds.
Pairing process can take up to 9 minutes.
Once devices are successfully paired, LED on the receiver will go
solid red. Press and hold TEST / PAIRING button for 3 seconds to
end the pairing process.
Remove the batteries without pressing any button. Wait 2
minutes and insert the batteries again. Your device will be
restarted.
When you want to change the batteries your device will use the
internal memory to backup your settings. You have 30 seconds
to change the batteries before losing your settings.
Note:
If you do not notice the “low battery” symbol displayed
on the screen in time, it will shut down. In this case, after
removing the old batteries, it is necessary to wait 5 minutes
before inserting the new batteries. Otherwise, it is possible that a
condenser will remain partially discharged and it can prevent the
thermostat from restarting.
Press TEST / PAIRING button again to return to the main screen.
Press three buttons at the same time for 3 seconds.
Press TEST / PAIRING button to check the connection with the
receiver.
B E G I N T H E PA I R I N G P R O C E S S
E N D T H E PA I R I N G P R O C E S S
T E S T T H E PA I R I N G P R O C E S S
Note:
For the
CFE
pack, the pairing between the thermostat
and the receiver is already done.
If you want to re-pair thermostat with the receiver, make sure
that the device is disconnected from the power supply and the
switches on the receiver have been set to AUTO and ON. Then
connect the receiver to the power supply and wait for the red
LED to light steadily. Then switch to the OFF position and again
to ON position quickly. The red flashing LED will confirm entering
the pairing mode.
Press any button to stop the Sleep Mode.
The Frostpoint temperature can be reviewed by pressing the
button once, but can only be changed in Installer Mode.
ON
AUTO
OFF
MANUAL
D X X
F U N C T I O N
P A R A M -
E T E R
D E F A U L T
V A L U E
d01
Temperature display
increments
0.1°C or
0.5°C
0.5°C
d02
Temperature offset
± 3.0°C
0.0°C
d03
Frost Protection set-
point temperature
5.0°C -
17.0°C
5.0°C
COSMO
GmbH
Brandstücken 31
22549 Hamburg
[email protected]
www.cosmo-info.de
February 2020
V003
TEST / PAIRING
3 sec
3 sec
3 sec
3 sec
1 sec
3 sec
3 sec
3 sec
3 sec
3 sec
1 sec
