COSMO Bully FLS105, Руководство по эксплуатации

Страница: 12 / 22

12
4.3 Storage
The machine inside and outside shall be cleaned carefully so as to avoid corrosion.
Don’t spray water on the rolling bearing if you clean the machine with high pressure
sprayer.
Check and clean the universal joint, driving belt press roller, or replace them if they are not
in good state.
Spread oil on all parts required.
Repaint parts with damaged paint to prevent rust.
Store the machine in a dry, level area. Support the frame with planks if require.
4.4 Operation After Storage
Before the machine is started up, check the following items regularly:
Check oil level and add it if not enough.
Check and tighten all screws and nuts;
Check the regulated state of the machine.
Check the blade state.
Check the air hole on the gearbox. If it is blocked, clean or open the hole with compressed
air.
Don’t spread oil or grease on the driving belts. If there is oil or grease on the belts, wipe the
belts, in case the belt sliding and wearing occur.
ATTENTION: Check the machine every 10 hours. Repair the damaged
parts or replace the blade according to the manufacturer’s
recommendation, to keep the machine balancing.
Check all tightening parts and replace them if necessary.
Don’t remove the protective parts on some points and protect the machine.
ATTENTION: In the case of vibration, stop the machine and check the
blade. If the blade breaks or is damaged, replace it with
same type of the blade. If the machine vibrates still, send
the machine to the authorized repairer.