5
Connecting to a Gas Cartridge
•
If the gas lantern is fitted to an empty cartridge, then
please read “Removing Cartridge”.
•
Remove the glass and stone before removing the
attached cartridge.
•
This gas lantern is fitted with a sealing washer. Check the
sealing washer is present and in good condition before
connecting the cartridge.
•
Do not use if the seal is damaged or worn.
•
Do not use appliances that are leaking, damaged or do
not function properly.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames, any other
ignition source and other people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Screw out the cartridge cover anticlockwise; attach the gas cartridge and screw in the cartridge cover
clockwise.
If there is a smell of gas or you suspect a leak once the cartridge has been
fitted, take the appliance to a well-ventilated outdoor location away
from any ignition sources. If you want to check for leaks in your
appliance, do so outside. Do not try to detect leaks using a flame; use
soapy water.
•
Replace stones and glass as instructed, then put a
layer of stones in. The stones shall not cover the
burner.
•
Place the Cosiscoop on a hardened, non-flammable
and clean surface or on a table that can bear weight.
Make sure the Cosiscoop is stable and level.
•
Hold a long lighted lighter (with a minimum length of
140mm) near the burner and slowly open the control
knob anticlockwise (ON).
•
If the burner does not light after 5 seconds, turn off
gas valve and wait 10 seconds before re-lighting.
•
If unit does not light after several attempts, contact
your retailer.
•
Avoid moving the gas lantern once lit because this
could be dangerous.
•
Always operate the gas lantern at least 1m away from walls and ceilings and never near flammable
materials.
CAUTION
: accessible parts of this gas lantern may become very hot during and after use. Handle with care.
Keep young children away from this appliance.
•
Extinguish by turning control knob fully clockwise (OFF). Check that the gas lantern is fully
extinguished before leaving unattended.
•
Always store the gas lantern in a well-ventilated area.
Removing the Cartridge
•
Only change gas cartridges if they are empty.
•
Make sure the gas lantern is off by turning the control knob fully anticlockwise and checking that the
gas lantern has fully extinguished.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames and any
other ignition sources.
190 gr gas
cartouche
Lock gas
cartouche
sealing
