Cosen V2230NC, Инструкция по эксплуатации

Страница: 46 / 122

4 ‐ 12
No Item Function Description
13
PLC monitor
Shows current PLC signals.
14
Material cutting
reference
This 2 ‐ page reference chart lists out the required
blade speed and cutting rate for each different
material.
15
Error report Lists a historical report of the errors and the time of
occurrence as well as provides troubleshooting
support. 6 pages in total.
16
Saw bow rear limit
switch display
After the cut is finished, blade will stop running and
saw bow will move backward automatically until it
touches the rear limit switch and the RED light will
come on.
17
Saw bow left limit
switch display
When saw bow touches left limit switch and red right
is on, it means saw bow inclines left max. 150°.
18
Saw bow right limit
switch display
When saw bow touches right limit switch and red
light is on, it means saw bow inclines right max. 30°.
19
Saw bow front limit
switch display
When saw bow cuts or moves forward and touches
the front limit switch, the RED light will come on
which means the cut is finished or saw bow already
reaches the end.
All limit switches have been set up by the
manufacturer before shipment. Make random
changes will affect cutting precision.
20
Guide arm safety
position display
Indicates if the guide(saw) arm is within its safety
range for the saw bow to move forward. This safety
design prevents the saw arm from being improperly
positioned and hitting the workbed while blade
moves forward.

Light on: Saw bow has reached the minimum
height and is not allowed to descend any
further. Raise the
saw bow again, check on the
saw arm position and move it to a safer place.

Light off: Saw arm is at a proper height and
within the safe range.
21
Angle setting Key ‐ in ###.# in HMI, press “Swivel” and saw bow
inclines to the setting angle.
Saw bow must be at rear limit switch position
to swivel.
When adjusting the angle of saw bow
manually, actual angle and angle displayed on the
screen need to match for the machine to start
cutting.