Cosen SH-1000F, Инструкция по эксплуатации

Страница: 39 / 104

4 ‐ 5
Control Buttons
1. Power indicator lamp
When the lamp is on, it indicates the power to the machine is turned on.
2. Hydraulic start button (with built ‐ in ‐ lamp)
When the button is pressed, the built ‐ in ‐ lamp will come on and the hydraulic motor starts to operate.
When the hydraulic motor is ON, the chip conveyor will run at the same time, please keep your
hands away from the chip conveyor.
Press the emergency stop button to stop the hydraulic system.
The hydraulic system will not start when the saw bow is at the lower limit position.
3. Blade start button (with built ‐ in lamp)
When the button is pressed, the built ‐ in ‐ lamp will come on and the blade motor starts to operate.
The blade will start to descend according to the preset cutting pressure and blade descend feed (later
introduced in blade descend pressure and speed control panel).
The blade motor will not start when the the saw bow is at the lower limit position.
The vise open/clamp switch must be turned to the right to “clamp” position and held for 2
seconds before the blade can start running.
While pressing the saw bow up button can stop the running blade, please still use the
emergency stop button in an emergency.
4. Emergency stop button
Press this button to stop the machine in an emergency. When the button is pressed, it brings the
machine to a full stop. The button locks when pressed. In order to unlock it, please turn the button
clockwise.
Also serves as the “hydraulic stop button.”
5. Blade speed indicator
Blade speed is shown here in predetermined unit (M/min or fpm).
All parameter settings have been done by Cosen factory before shipment. Please do not make
any random change to the parameter as it may affect the accuracy of the blade speed reading. Please
consult your agent shall there be any need to reset machine parameters.