Cosen MH-1016JA, Инструкция по эксплуатации, Страница: 43 / 114

OPERATING INSTRUCTION
SECTION 4
4-4
Turning the knob clockwise decreases the cutting pressure.
To obtain a good cutting result, choose the right cutting pressure by turning the knob
Note: The machine will stop automatically when the material has been cut through.
Warning: Before plugging the power cord, make sure the power on switch is turned off.
Warning: Press the power on button to start the machine, slowly lower the blade onto the
material to be cut. DO NOT enforce additional force on the blade or drop the blade to avoid blade or
material damage.
Check Prior to Operation
1. Make sure the blade has been installed properly i.e. the blade teeth are pointing in the right
direction.
2. Saw blade should be properly installed on the wheels after correct tension is applied.
3. Set carbide blade guides at an approximately 0.03” to 0.05” clearance between the guides and the
blade.
4. Check for slight clearance between guide rollers and the back of the blade.
5. Have the guide arms as close to the workpiece as possible.
6. Select proper blades speed and cutting pressure.
7. Material should be securely clamped by the vise.
8. Turn on the coolant if required (based on material to be cut.)
9. Avoid starting your cut on a sharp edge.
10. Keep machine properly lubricated.