Cosen CNC-800DM, Инструкция по эксплуатации, Страница: 42 / 148

4 ‐ 6
5. Saw bow down button
When this button is pressed, the saw bow descends.
This machine incorporates a blade descend clearance check feature to control and ensure the
blade can be lowered only when it is safe to do so. For more information, refer to HMI control panel
in later section.
The blade comes down at first quick then the preset downfeed speed. Please refer to
supplementary notes previously explained in No. 3 saw blade start button.
6. Rear vise open button
This button only works when the machine is switched to manual mode. When this button is pressed,
the rear vises will open until the operator lets go of the button or until the vises are fully opened.
7. Rear vise clamp button
This button only works when the machine is switched to manual mode. When this button is pressed,
the rear vises will close until the operator lets go of the button or until the vises are fully closed.
Rear vise cannot clamp the inclined plane of the material, or it might damage the machine.
Therefore material end cannot be an inclined plane.
8. Front vise open button
This button only works when the machine is switched to manual mode. When this button is pressed,
the front vises will open until the operator lets go of the button or until the vises are fully opened.
If the saw bow is not at the upper limit switch position, the front vise can only be opened in
small increments, so as to prevent the vise from hitting the guide arm.
9. Front vise clamp button
This button only works when the machine is switched to manual mode. When this button is pressed,
the front vises will close until the operator lets go of the button or until the vises are fully closed.
Front vise cannot clamp the inclined plane of the material, or it might damage the machine.
Therefore material end annot be an inclined plane.
10. Front movable vise backward button
Front vise moves backward when this button is pressed.
This button is enabled only when the saw bow is at its top most position.