Cosen C-260NC, Инструкция по эксплуатации, Страница: 58 / 132

4 ‐ 22
Step 6 ‐ Open the idle and drive wheel covers.
Step 7 ‐ Press the Blade Clip device to hold onto the blade. This device makes blade changing easy
and feasible even with only one operator available.
Step 8 ‐ Loosen the left and right carbide inserts by loosening the “lock nut” shown below.
Step 9 ‐ Open the wire brush cover. Loosen the lock lever and lower the wire brush.
Step 10 ‐ Remove the old blade. If necessary, clean the carbide inserts before installing a new saw
blade.
Step 11 ‐ Place the new blade around the idle wheel and the drive wheel.
Step 12 ‐ Insert the blade into the left and right tungsten carbide inserts. The back and the sides of
the blade need to be touching the inserts as well as the adjacent rollers.
Step 13 ‐ Place the blade to the drive wheel and press the back of the blade against the flange of the
drive wheel. Use the Blade Clip device to tightly hold the blade from falling out of the
drive wheel.
When saw blade begins to rotate, the blade holder will automatically release the blade
and fall back to its original position.
Step 14 ‐ Make sure the back of the blade is also pressed against the flange of the idle wheel.
Blade Clip
Lock Lever
Wire Brush Case