Choosing Rear or Forward Facing
9.
Secure Child in
Child Restraint
Recheck level line.
Repeat steps 5-8
if level line is not
parallel with the
ground.
You may need to
place a large rolled
towel(s) or foam pool
noodle(s) under front
of child restraint
to help make level
line parallel with the
ground.
Check often to be sure padding is still in
place and the belt is tight.
35
To Release LATCH
Remove child from
child restraint.
Remove tension
from LATCH belt by
pushing down on
side of child restraint
with LATCH adjuster.
Then press adjuster
button to loosen belt.
Unhook LATCH from
bar by squeezing
spring lever, pushing back into the seat
bight and twisting the hook. Then pull it
out of the vehicle seat.
Store LATCH when not in use. See
page 25.
Vehicle Belt Installation
36
1.
Place Child
Restraint Rear
Facing in Back
Seat
For children who
cannot sit up
unassisted
, the
level line on shell
MUST
be parallel
with the ground.
For children who can sit up
unassisted
, you may rotate the child
restraint to be more upright.
WARNINGS:
Do not use LATCH
belts along with the
vehicle lap or lap/
shoulder belt. Secure
LATCH belts as shown
when using vehicle
belts.
When the child
restraint is used rear
facing, you MUST
secure the tether hook to the stor-
age attachment and gently tighten to
remove slack.
Check vehicle belt before each use. Use
only if belt can be tightened properly
and locked securely in place.
Failure to follow these warnings can
result in serious injury or death.
Safety Tip
Make sure harness
and buckle fit your
child correctly before
installing the child
restraint. See pages
3-4.
continued on next page
4358-6590B Scenera NEXT.indd 34-35
4358-6590B Scenera NEXT.indd 34-35
5/6/15 3:25 PM
5/6/15 3:25 PM